

Raw stock  2.5 by 3.475 by 1 inches.

Vice is on table such that the fixed jaw on on the left (-X) direction.
Origin is front top right  (+X, -Y, -Z corner of left (fixed) jaw.

Put stock into vice, so a bit sticks out in -Y.
Run pump_chamber_top_1.ngc

Rotate stock around Y axis 180 degrees.
Run pump_chamber_top_2.ngc

Rotate stock around X axis 90 degrees.
Run pump_chamber_side_1.ngc

Rotate stock around Y axis 180 degrees.
Put stock in such that the tab presses against the -Y side of the vice,
Run pump_chamber_side_2.ngc

Rotate stock around the Y axis 90 degrees
Put stock in such that both tabs press against the -Y side of the vice,
with 0.995 inch block underneath.
Run pump_chamber_front.ngc

Rotate stock around the Y axis 180 degrees
Put stock in such that both tabs press against the -Y side of the vice,
with 0.995 inch block underneath.
Run pump_chamber_back.ngc

Rotate the stock about the Y axis 90 degrees and X axis 90 degrees (IE:bottom up)
put in the vice, such that the face is even with Y=0 (tab extends)
run pump_chamber_mounting.ngc



Errors:

rod hole is   0.483 to 0.490  should be 0.502

lamp hole is  0.455 to 0.462    shold be 0.472
lamp Oring is 0.580 to 0.588  should be 0.598

tube body 1.856 to 1.992  should be 2.001

add 11 mils to diameters


stock is 1.025 inches thick,  not 1.000


Rod clamps are slightly over 1/16 of an inch too far apart, needlessly
shadowing the ruby.  The distance between the end caps is about 5 mils off,
so the model is otherwise very accurate...
